Wet Decal Installation for Accent Letters:

Installation should take place out of direct sunlight

Between 65 and 80 Fahrenheit outside.

You will need the following items:

Lint Free Paper Towels or Micro Fiber Cloth

16oz or 32oz Spray Bottle

Dish Soap or Baby Shampoo

Water

Isopropyl Alcohol

Making Application Fluid: (16oz Directions)

Fill 80% of Spray Bottle with Water.

Put 4 drops of Dish Soap or Baby Shampoo into the Spray Bottle.

Put 4 Tbs of Isopropyl Alcohol into the spray Bottle.

Screw on the Sprayer Nozzle and give a good shake to mix.

Let rest for a couple minutes before use to combine.

Installation of your Accent Letter Sticker Decals:

Clean Accent Letter area with isopropyl alcohol to remove any oil, wax, dirt or grime. Preparation is the most important step for best results.

DO NOT WET STICKER BACKING or it will not release cleanly.

With that said Spray first Accent Letter area on vehicle with Application Fluid.

Remove first letter from the backing paper and spray the sticky side with the application fluid.

Position the letter on Accent Letter Area while both sticker and vehicle panel wet. You can position it at this time for a brief moment before adhesion occurs.

Lightly use your Finger to rub the decal to the vehicle. Squeegeeing the solution out from underneath it. Repeat with a little more pressure each pass.

Gently dry the area and repeat for all the remaining letter inserts. Making sure your hands are dry when removing next letter from backing again.

When all letter Inserts are installed. Allow to dry for 24-48 hours before hand washing vehicle. Full cure will take a week before waxing area. Bubbles are sometimes present from Application fluid and will disappear within a week during drying, like window tint drying.

Pin It on Pinterest

Share This